Pick two letters out of a hat.  Interpret them in 3D.

1) Inspired by a “floating” bed design where the base was basically a T on its side.

2) I wanted to do something which would look more difficult to make than it actually was.  This was done by carving the full L and T as if they were extrusions, then taking a 3mm slice off the end of each extrusion and hollowing it out to an outline.  The outline was glued back on to the parent piece and the seam sanded smooth.


Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

%d bloggers like this: